Bought new in 2017. Used as my trem equipped rehearsal workhorse. Modifications include, Original Floyd Rose and floyd nut with steel trem block. Full rewire with CTS pots and switchcraft 5 way switch and jack. Dimarzio Satchur8 in the bridge and Fred bridge in the neck position. Factory middle. Abalone knobs. The wiring is a master coil split on the tone pot. Position 1 Bridge, 2 Bridge and Middle, 3 Middle, 4 Middle and Neck. The frets are leveled and dressed action is low intonation is perfect, stays in tune, plays 10 out of 10. This guitar is not pristine. I have highlighted the cosmetic damage. First, Floyd requires routing to install. I didn’t route for it, knowing it would cause the corners of the route to chip. This is marked in photos. The finish damage on the lower back of the body was caused by a well intended helper letting it hit concrete from about 6″ off the ground while holding vertically. The chips were repaired and the finish is stable. There is no structural damage to the guitar. It’s a stone cold killer deal. Clearing out duplicates and stuff I don’t play often.
